Back to Blog
Affinity 567/21/2023 Preceded by fixed inlet guide vanes with movable flaps, the twin blisk fans have wide-chord titanium blades. The 18,000 lbf (80 kN) GE Affinity has a nine-stage HP compressor, a single-stage HP turbine and a two-stage low-pressure turbine. It lacks an afterburner, and has a combustor with advanced coatings and uses additive manufacturing technologies. The twin-shaft, twin-fan engine with FADEC has a service ceiling of 18,300 m (60,000 ft). The high-pressure core is derived from the nine-stage compressor and single-stage turbine of the CFM56, matched to a new low-pressure section optimised for supersonic speed with a 133 cm (52in) diameter fan instead of the 155-173 cm (61-68.3in) fan of the 6:1 bypass ratio CFM56. The engine is a compromise between a large core for power and a small fan for wave drag, and Mach 1.4 is a compromise between higher speed and enough range. This is limited by noise regulations at takeoff, and a lower compression core like the CFM56 is better suited to higher temperatures encountered supersonically. Īn engine for supersonic flight needs a lower bypass ratio than modern turbofans, and a higher flow speed for better efficiency. Managing the high intake temperatures at high altitudes is a key challenge for the initial design. GE Aviation needed to develop a configuration accommodating reasonable requirements for supersonic speed, subsonic speed and noise levels. įollowing the collapse of Aerion on, GE Aviation discontinued development of the Affinity engine, leaving no supersonic turbojet supplier for the Boom Overture, after Rolls-Royce also announced the end of their involvement in the project. The detailed design review was expected to be completed by 2020 for the prototype production. The initial design of its Affinity medium-bypass-ratio turbofan was completed by October 2018. Thrust was reduced at takeoff to meet Chapter 5 noise regulations, requiring a longer balanced field takeoff as an acceptable compromise.Ĭhapter 5 applies from 2018 to over 120,000 lb (54,400 kg) aircraft and all aircraft from 2021. In February 2018, Aerion released the GE engine configuration. The Affinity high-pressure core was adapted from the CFM56 and the GE F101/ F110 military engines. The final engine configuration was a core with billions of operational hours – suggesting the CFM56 – and a new low-pressure section optimized for supersonic speed. Its high-pressure core is derived from the CFM56, matched to a new twin fan low-pressure section for a reduced bypass ratio better suited to supersonic flight.Īt the May 2017 EBACE, Aerion announced the selection of GE Aviation to power the Aerion AS2 supersonic business jet. GE Aviation discontinued development of the engine in May 2021. The General Electric Affinity was a turbofan developed by GE Aviation for supersonic transports.Ĭonceived in May 2017 to power the Aerion AS2 supersonic business jet, initial design was completed in 2018 and detailed design in 2020 for the first prototype production. Supersonic aircraft engine design Affinity
0 Comments
Read More
Leave a Reply. |